ZyXEL Communications Prestige 28641, User Manual

Page: 25 / 159

Before You Begin 11
long waits common when ordering a new line. Use the information in
this section to place the order (see Chapter 16 for information on
provisioning your ISDN line). If you have already installed your ISDN
line, you can check the following section to make sure that you can use
all the features of your Prestige.
1. Contact your local telephone company’s ISDN Ordering Center.
2. Find out what type of ISDN service is available. Refer to Chapter
16 to find out the provisioning information for the appropriate
switch type and ISDN service. For the U.S., the Prestige (both U
and S/T Interface) have been approved by Bellcore and have IOC
(ISDN Ordering Code) “S” Capability, EZ-ISDN 1.
3. Provide your telephone company with the proper provisioning
information.
4. When the telephone company installs your ISDN line, be sure to
obtain the following information:
•
ISDN switch type.
•
ISDN telephone number(s).
•
ISDN Service Profile Identifiers (SPID) number(s) (only for
North America).
Collecting General Setup Information
The Prestige requires the following system information. You can obtain
all the pertinent information from your network administrator. Record
this information into the worksheet as it becomes available. This
worksheet will later be referred to as you configure your Prestige.
•
System Name - This is the name given to the Prestige for
identification purposes. This name should be no more than 8
alphanumeric characters. Spaces are not allowed, but “-” and “_”
are accepted. This name can be obtained remotely via the SNMP