Bridging Configuration 93
•
PPP Options: Recv. Authen.
- verify that this field is
not
set to
None Bridging applications must have some sort of authentication
turned on in order to match to a Remote Node.
Once you have completed filling in the menu, press ENTER at the
message: Press
ENTER
to Confirm ... to save your selections, or press
ESC
at any time to cancel your selections.
Bridge Static Route Setup
You can configure Bridge static routes for your Bridging applications.
Figure 9-3 Menu 12.4 - Bridge Static Route
1.
Route Name
- For identification purposes enter a name for the
bridge static route.
2.
Active
- Indicates whether the static route is active or not.
3.
Ether Address
-Enter the MAC address of the destination device
that you wish to bridge your packets to.
4.
IP Address
- If available, enter the IP address of the destination
device that you wish to bridge your packets to.
5.
Gateway Node
- Enter the number (1-4) of the Remote Node that
is linked to this static route. When an incoming packet’s destination
Summary of Contents for Prestige 28641
