ZyXEL Communications Prestige 100, User Manual

Page: 34 / 130

22 Installation
the correct cable for each connection; otherwise, your Prestige
could be damaged.
Connecting Your Computer and Your Prestige
For the initial setup of your Prestige, you must use RS-232 and
communication software to configure the Prestige.
After the Prestige has been successfully installed, you can modify
the configuration through a remote Telnet connection. See Chapter
10 for detailed instructions on using Telnet to configure your
Prestige.
Connecting the RS-232 Cable to your Prestige
One 9-25 pin adapter is included in your package. To connect a
RS-232 cable, connect the 9-pin end of the cable to the DTE port
on the back panel of the Prestige. Connect the other end to the RS-
232 cable connected to the serial port (COM1, COM2, or any other
COM port) of your computer.
Connecting an ISDN Line to your Prestige
Plug one end of your ISDN phone line which is included in your
package into the socket on the rear panel of the Prestige labeled
‘ISDN’ and the other end into the ISDN wall jack.
•
S/T interface - This can only connect to your NT-1 (Network
Termination) device.
:DUQLQJ :DUQLQJ 'RQRWXQGHUDQ\FLUFXPVWDQFHVFRQQHFWGLUHFWO\WRWKH,6'1ZDOOMDFN
•
U interface - This allows you to connect directly to your ISDN
wall jack.
:DUQLQJ :DUQLQJ 7KH,6'1MDFNLVIRU,6'1OLQHFRQQHFWLRQRQO\&RQQHFWLRQRIDSKRQHOLQH
PD\UHVXOWLQGDPDJHWR\RXU3UHVWLJH