Chapter 8 Routing
PMG2006-T20A User’s Guide
69
8.5.1 The RIP Screen
Click
Network Setting > Routing > RIP
to open the
RIP
screen.
Figure 36
RIP
The following table describes the labels in this screen.
Table 23 RIP
LABEL
DESCRIPTION
#
This is the index of the interface in which the RIP setting is used.
Interface
This is the name of the interface in which the RIP setting is used.
Version
The RIP version controls the format and the broadcasting method of the RIP packets that the
PMG2006-T20A sends (it recognizes both formats when receiving). RIP version
1
is universally
supported but RIP version
2
carries more information. RIP version
1
is probably adequate for
most networks, unless you have an unusual network topology.
Operation
Select
Passive
to have the PMG2006-T20A update the routing table based on the RIP packets
received from neighbors but not advertise its route information to other routers in this interface.
Select
Active
to have the PMG2006-T20A advertise its route information and also listen for
routing updates from neighboring routers.
Enable
Select the check box to activate the settings.
Disable Default
Gateway
Select the check box to set the VMG to not send the route information to the default gateway.
Apply
Click
Apply
to save your changes back to the PMG2006-T20A.
Cancel
Click
Cancel
to restore your previously saved settings.
Summary of Contents for PMG2006-T20A
Page 11: ...11 PART I User s Guide ...
