ZyXEL Communications P8802T, User Manual

Page: 86 / 278

Chapter 4 WAN
Basic Home Station VDSL2 P8802T User’s Guide
86
Figure 22
WAN Configuration: Service Type
Figure 23
The following table describes the labels in this screen.
Table 19
WAN Configuration: Service Type
LABEL DESCRIPTION
Select WAN
service type Select the method of encapsulation used by your ISP.
Choices are PPP over Ethernet (PPPoE), IP over Ethernet and Bridging.
Enter Service
Description Specify a name for this connection or use the automatically generated one.
Rate Limit Enter the maximum transmission rate in Kbps for traffic sent through the WAN connection.
Otherwise, leave this field blank to disable the rate limit.
This field is not available for an ATM connection if QoS is disabled in the DSL ATM Interface
Configuration.
Tag VLAN ID for
egress packets Select this option to add the VLAN tag (specified below) to the outgoing traffic through this
connection.
This field is available when the layer-2 interface is in VLANMUX mode.
Enter 802.1P
Priority
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer
frame that contains bits to define class of service.
Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection.
The greater the number, the higher the priority level.
This field is available when the layer-2 interface is in VLANMUX mode.
Enter 802.1Q
VLAN ID
Type the VLAN ID number (from 1 to 4094) for traffic through this connection.
This field is available when the PTM interface is in VLANMUX mode.