ZyXEL Communications P8802T, User Manual

Page: 64 / 278

Chapter 3 Device Info Screens
Basic Home Station VDSL2 P8802T User’s Guide
64
Each field is described in the following table.
3.4 The 3G Status Screen
Log into the VDSL Router’s web configurator and click Device Info > 3G to view a summary screen
of information about the VDSL Router’s 3G connection.
Table 3
WAN Info Screen
LABEL DESCRIPTION
Interface This shows the name of the interface used by this connection.
A default name ipoa*, pppoa*, atm* or ptm* indicates DSL port. The ppp* indicates a
PPP connection via any one of the WAN interface.
The number after the dot (.) represents the VLAN ID number assigned to traffic sent
through this connection. The number after the underscore (_) represents the index number
of connections through the same interface.
(null) means the entry is not valid.
Description This is the service name of this connection.
0 and 35 or 0 and 1 are the default VPI and VCI numbers. The last number represents the
index number of connections over the same PVC or the VLAN ID number assigned to traffic
sent through this connection.
(null) means the entry is not valid.
Type This shows the method of encapsulation used by this connection.
VlanMuxID This indicates the VLAN ID number assigned to traffic sent through this connection. This
displays N/A when there is no VLAN ID number assigned.
IPv6 This displays whether or not IPv6 is enabled on the interface.
Igmp This shows whether IGMP (Internet Group Multicast Protocol) is activated or not for this
connection. IGMP is not available when the connection uses the bridging service.
MLD This shows whether Multicast Listener Discovery (MLD) is activated or not for this
connection. MLD is not available when the connection uses the bridging service.
NAT This shows whether NAT is activated or not for this interface. NAT is not available when the
connection uses the bridging service.
Status This displays the connection state or Unconfigured if the interface has not yet been
configured.
IPv4 Address This displays the interface’s current IPv4 address if it has one. Click connect to initiate the
WAN interface’s connection.
IPv6 Address This displays the interface’s current IPv6 address if it has one. Click connect to initiate the
WAN interface’s connection.