ZyXEL Communications P-660HWP-D1, User Manual

Page: 341 / 374

P-660HWP-D1 User’s Guide
341
A
P P E N D I X
E
Command Interpreter
The following describes how to use the command interpreter. You can telnet to access the CLI
(Command Line Interface) on the P-660HWP-D1. See the included disk or zyxel.com for
more detailed information on these commands.
1
Use of undocumented commands or misconfiguration can damage the unit and
possibly render it unusable.
Accessing the CLI
Use the following steps to telnet into your P-660HWP-D1.
1 Connect your computer to the ETHERNET port on the P-660HWP-D1.
2 Make sure your computer IP address and the P-660HWP-D1 IP address are on the same
subnet. In Windows, click
Start (usually in the bottom left corner), Run and then type
telnet 192.168.1.1
(the default P-660HWP-D1 IP address) and click OK .
3 A login screen displays. Enter the default admin password "1234".
Command Syntax
• The command keywords are in
courier new
font.
• Enter the command keywords exactly as shown, do not abbreviate.
• The required fields in a command are enclosed in angle brackets
<>
.
• The optional fields in a command are enclosed in square brackets
[]
.
• The
|
symbol means or.
For example,
sys filter netbios config <type> <on|off>
means that you must specify the type of netbios filter and whether to turn it on or off.
Command Usage
A list of valid commands can be found by typing
help
or
?
at the command prompt. Always
type the full command. Type
exit
to log out of the CLI when finished.