ZyXEL Communications P-202H Plus v2, Support Notes

Page: 178 / 434

P-202H Plus v2 Support Notes
See the screen shot:
10. Enter Cisco commands mode from console and check if Cisco can make
a successful ping to P-202H Plus v2. You might have to tune the
configuration to accommodate your practical environment. For more
detailed information, please go to http://www.cisco.com
11. In config mode , enter a command " crypto ipsec transform-set cm-
transformset-1 esp-des esp-md5-hmac ".
12. After all of the settings, if PC1 and PC2 can reach each other, then IPSec
VPN has been established successfully. There is also an useful command
to debug IPSec VPN, "
debug crypto ipsec ".
2.2 Setup Cisco by Commands
Note that, in order to setup Cisco by commands, you have to connect your PC
and Cisco route by a console cable. Enter the following commands one per line.
All contents copyright © 2006 ZyXEL Communications Corporation.
178
Cisco1720# config
Cisco1720# <start typing the commands below>