ZyXEL Communications MES3500-24, User Manual

Page: 162 / 349

Chapter 18 Port Authentication
MES3500-24/24F User’s Guide
162
18.2.3 Activate MAC Authentication
Use this screen to activate MAC authentication. In the Port Authentication screen click MAC
Authentication to display the configuration screen as shown.
Figure 80
Advanced Application > Port Authentication > MAC Authentication
Host-mode Specify how the Switch authenticates users when more than one user connect to the port
(using a hub).
Select Multi-Host to authenticate only the first user that connects to this port. If the first
user enters the correct credential, any other users are allowed to access the port without
authentication. If the first user fails to enter the correct credential, they are all put in the
guest VLAN. Once the first user who did authentication logs out or disconnects from the
port, rest of the users are blocked until a user does the authentication process again.
Select Multi-Secure to authenticate each user that connects to this port.
Multi-Secure
Num If you set Host-mode to Multi-Secure, specify the maximum number of users (between
1 and 5) that the Switch will authenticate on this port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 44
Advanced Application > Port Authentication > 802.1x > Guest VLAN (continued)
LABEL DESCRIPTION