ZyXEL Communications MES3500-24, User Manual

Page: 153 / 349

Chapter 17 Link Aggregation
MES3500-24/24F User’s Guide
153
17.5 Link Aggregation Control Protocol
Click in the Advanced Application > Link Aggregation > Link Aggregation Setting > LACP to
display the screen shown next. See
Section 17.2 on page 148 for more information on dynamic link
aggregation.
Figure 71
Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
The following table describes the labels in this screen.
Table 42
Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL DESCRIPTION
Link Aggregation
Control Protocol
Note: Do not configure this screen unless you want to enable dynamic link aggregation.
Active Select this checkbox to enable Link Aggregation Control Protocol (LACP).
System Priority LACP system priority is a number between 1 and 65,535. The switch with the lowest
system priority (and lowest port number if system priority is the same) becomes the LACP
“server”. The LACP “server” controls the operation of LACP setup. Enter a number to set
the priority of an active port using Link Aggregation Control Protocol (LACP). The smaller
the number, the higher the priority level.
Group ID The field identifies the link aggregation group, that is, one logical link containing multiple
ports.