ZyXEL Communications ARMOR G1, User Manual

Page: 15 / 183

Chapter 1 Introduction
NBG6818 User’s Guide
15
Figure 5 Rear Panel
1.8 Desk Mounting
Place the side of the NBG6818 with rubber feet carefully on the desk.
1.9 Wall Mounting
You may need screw anchors if mounting on a concrete or brick wall.
Figure 6 Screw Specifications
1
Select a position free of obstructions on a wall strong enough to hold the weight of the device.
2
Mark two holes on the wall at the appropriate distance apart for the screws.
Be careful to avoid damaging pipes or cables located inside the wall when
drilling holes for the screws.
3
If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the full
depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way in - leave
a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the screws all
the way in - leave a gap of about 0.5 cm.
Table 2 Wall Mounting Information
Distance between holes 10.50 cm
M4 Screws Two
Screw anchors (optional) Two