ZyXEL Communications 2864 Series, User Manual, Page: 111 / 267

9–1
Chapter 9
AT COMMAND SET SUMMARY
An
AT
command is a command issued by the computer/terminal to the modem
through the asynchronous computer-modem interface in asynchronous data for-
mat.
AT
commands control the modem's behavior and actions. To send an
AT
command from a computer to the modem, you must be running a communication
software and the modem must be in command state.
An
AT
command prefix (ATtention) precedes each command line, except in the
case of
A/
,
A>
, and
+++
.
A/
re-executes the last command once.
A>
re-executes
the last command once, and repeats the last call up to 9 times until aborted by
physically pressing any key on the keyboard or front panel or until a successful con-
nection with a remote modem has been made. These commands are not preceded
by
AT
or followed by more characters. Up to 40 commands can be entered in a
command line with a single
AT
prefix. Be sure to either use all capital letters (AT)
or none at all (at).
+++
is the escape sequence code that is entered in data state to return the modem
to command state. The modem will accept
AT
commands only while it is in com-
mand state.
Basic AT Command Set
A list of the basic AT command set follows. Each command should be entered after
an AT prefix. A plus sign (
+ ) placed before a command in the list indicates that it is
a default setting.
A
Goes on-line in answer mode. (See also
S39b2
,
S43b6
)
+
B0
Selects ITU-T V.22 for 1200 bps communication. (Default)
B1
Selects Bell 212A for 1200 bps communication.
D
Enters originate mode, dials the number that follows; attempts to go
on-line. (See also
S35b4
,
S38b0
)
Digits and modifiers that can be used with the
D
command:
0-9
,
#
,
*
Digits for dialing.
P
Pulse dial.
T
Tone dial.
W
Wait for a second dial tone. (See also
S6
)