ZURN Aquaflush Z6000, Installation, Operation, Maintenance And Parts Manual

Page: 21 / 89

Page 3
STEP NO. 1
Measure distance from finished wall to center line of fixture spud;
cut water supply pipe 1-1/4" shorter than this mea sure ment.
Chamfer O.D. and I.D.
STEP NO. 3
Measure from finished wall to first thread of adapter for length of
chrome tube. Cut chrome tube this length ‘x’.
STEP NO. 4
Slide wall escutcheon over chrome tube and slide both chrome
tube and wall escutcheon over supply pipe pushing the wall
escutcheon all the way to the wall.
STEP NO. 2
Slide threaded adapter onto supply pipe until shoulder stops on
end of pipe. Then sweat-solder the adapter to water supply pipe.
Sweat Solder Adaptor Installation Instructions
Important:
• All plumbing is to be installed according to state and local
codes and regulations.
• Water supply lines need to allow proper water flow for each
fixture.
• Flush all lines of any debris before making connections.
• Do not use pipe sealant or plumbing grease on any fitting
other then the control stop inlet.
The Aquaflush valve is designed to operate under various water
pressures with a recommended range between 10 and 100 psi
(69 to 689 kPa). Each Zurn valve is tested for proper performance
at the factory before being shipped. Consult the product pages of
the catalog for available flow options.
Most low consumption fixtures (1.28 and 1.6 gallon) require
a minimum of 25 psi running pressure through the valve to
obtain proper evacuation. Please be sure to consult fixture
manufacturer on minimum running water supply requirements
for proper evacuation.
When installing your quality Zurn valve it is rec om mend ed that to
protect the polished finish you do not use a toothed wrench. This
will cause gouges and scratches on your valve.
STEP NO. 5
Screw control stop onto water supply water adaptor.