Note:
1: If the throttle is cut off after starting less 3 Seconds, then the next start will be as normal start.
If the throttle is cut off after starting more than 3 Seconds, the next start will be as soft start.
2: Once the Governor Mode is enabled, the ESC's Brake and Low Voltage Cutoff Type settings
will automatically be resetted to Brake Off and Reduce Power respectively, regardless of what
settings they were previously set.
3: Lower 50,000 turns is considered as Low KV motor,
100,000-200,000 turns is considered as High KV motor.
Formula : Pole's qty of motor x KV value x Voltage= Motor turns
For example: we test a 8 pole motor 1040KV with 6S Lipo, its turns will be
8x1040KVx25v=208,000 turns, so you can choose Governor Mode 2.
8. Motor Rotation: Forward/ Reverse
a. Turn on your radio and set the throttle stick to top positon (100%)
b. Plug the battery pack into your controller
c. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear
four single beeps to indicate you have successfully entered the programming mode
d. When you hear one long beep and 3 short beeps “Beep-----Beep-Beep-Beep” means you are
in the Motor Rotation menu, please choose your desired value by pulling the throttle stick to the
lowest position.
e. The system will automatically enter into next setting item when you nish one . If you do not
want to change other settings, unplug the power to exit.
There are two way to change the motor rotation:
a) by swapping any two motor wires
b) by programming with program box or radio.
9. Start Up Strength
a. Turn on your radio and set the throttle stick to top positon (100%)
b. Plug the battery pack into your controller
c. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear
four single beeps to indicate you have successfully entered the programming mode
7
2) Soft Start
: Soft Start 1: 8-second delay from start to full rpm;
Soft Start 2: 18-second delay from start to full rpm;
Note:
If the throttle is cut off after starting less 3 Seconds, then the next start will be as normal
start. If the throttle is cut off after starting more than 3 Seconds, the next start will be as soft
start.
Governor Mode 1
: There will be a 23-second delay from start to full rpm;If lower the throttle
to the 80% position of the full throttle or lower than 80% position, the RPM would be denitely
changed , the lost RPM will be detected and compensated automaticly by the ESC that makes
sure to keep the RPM at the same speed. (Note: This function is only for Low KV motor)
Governor Mode 2
: There will be a 23-second delay from start to full rpm;If lower the throttle
to the 80% position of the full throttle or lower than 80% position, the RPM would be denitely
changed , the lost RPM will be detected and compensated automaticly by the ESC that makes
sure to keep the RPM at the same speed. (Note: This function is only for High KV motor)
