Using the ESC
1. Turn on your radio and keep the throttle stick at the lowest position
2. Connect the battery pack to the ESC.
3. Motor emits two sets of audible tones in succession means the ESC is armed and ready to
use. The rst set of tone counting the cells of the battery the second set of means the status of
the brake setting.
Entering the programming Mode
1. Turn on your radio and set the throttle stick to top positon (100%)
2. Plug the battery pack into your controller
3. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear
four single beeps to indicate you have successfully entered the programming mode
Programmable Items
1. Brake
a. Turn on your radio and set the throttle stick to top positon (100%)
b. Plug the battery pack into your controller
c. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear
four single beeps to indicate you have successfully entered the programming mode
d. When you hear one short beep “Beep” means you are in the Brake menu, the default setup is
OFF, please choose your desired value by pulling the throttle stick to the lowest position.
e. The system will automatically enter into next setting item when you nish one . If you do
not want to change other settings, unplug the power to exit.
Note:
Brake Off
- Sets the propeller to freewheel when the throttle stick is at the minimum position.
Soft Brake
-Sets the propeller to the 30% of the brake when the throttle stick is at the minimum
position (Recommended for folding props).
Mid Brake
-Sets the propeller to the 60% of the brake when the throttle stick is at the
minimum position (Recommended for folding props).
Hard Brake
-Sets the propeller to the 100% of the brake when the throttle stick is at the
minimum position (Recommended for folding props).
2. Battery Type : NiCad/NiMH/LiPo
1. Turn on your radio and set the throttle stick to top positon (100%)
2. Plug the battery pack into your controller
3. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear
four single beeps to indicate you have successfully entered the programming mode
4. When you hear two short beeps “Beep-Beep” means you are in the Battery Type menu,
please choose your desired value by pulling the throttle stick to the lowest position.
5. The system will automatically enter into next setting item when you nish one . If you do
not want to change other settings, unplug the power to exit.
4
