ZXR10 2920/2928/2952
(V1.0)
Access Switch User Manual
（
Volume I
）
132
Confidential and Proprietary Information of ZTE CORPORATION
1. To configure ACL to a physical port, use the following
command in global configuration mode as shown in Table
199.
T
A B L E
1 9 9
P
O R T
C
O M M A N D S
Format
Mode
Function
set port
<portlist>
acl
<acl-number>
{enable |
disable}
global config
This
enables/disables
port ACL
set trunk
<trunktlist>
acl
<acl-number>
{enable |
disable}
global config
This
enables/disables
trunk ACL
set vlan
<valnlist>
acl
<acl-number>
{enable |
disable}
global config
This
enables/disables
Vlan ACL
Result:
This enables/disables port, trunk and Vlan.
Note:
A physical port can only have one ACL. It is
necessary to release the current bound when you want to
bind a new one in the case that an old one has applied to the
physical port, otherwise, a false message will return.
E
ND OF STEPS
ACL has been configured to a physical port
.
Quality of Service (QoS)
ZXR10 2920/2928/2952 provides QoS function and priority
control function. Priority of the data packets can be
determined by source MAC address priority of the data packets,
VLAN priority, 802. 1P user priority, layer 3 DSCP priority, or
the default port priority. The priority of a data packet is
determined in the following sequence:
Priority of the data packets sent by CPU (determined by CPU).
Priority of MGMT data packets (management data packets
such as the BPDU packets). Priority of the management
packets is determined by the initialization.
Priority of static source MAC address.
VLAN priority.
802. 1P user priority.
Layer 3 DSCP priority.
Default port priority.
Result
Data Packet
Priority
