Chapter 8
Access
Service
Confidential and Proprietary Information of ZTE CORPORATION
191
GARP has been configured.
Configuring GVRP
This topic describes the configuration of GVRP.
For the configuration of GVRP, perform the following steps.
1. To enable/disable GVRP, use command
set gvrp
in
global configuration mode. This is shown in Table 318.
T
A B L E
3 1 8
S
E T
G
V R P
C
O M M A N D
Format
Mode
Function
set gvrp
global config
This enable/disable
GVRP
Result:
This enable/disable GVRP.
Note:
By default, GVRP is disabled. GVRP is only enabled
when GARP is enabled.
2. To enable/disable GVRP in port, use command
set gvrp
port
<portlist>
{enable|disable}
in global configuration
mode. This is shown in Table 319.
T
A B L E
3 1 9
S
E T
G
V R P
P
O R T
C
O M M A N D
Format
Mode
Function
set gvrp port
<portlist>
{enable|disable}
global config
This enable/disable
GVRP in port
Result:
This enable/disable GVRP in port.
Note:
By default, GVRP in port is disabled. After enabling
GVRP in port, the port can receive packets of GVRP protocol.
3. To configure type of GVRP registration in port, use
command
set gvrp port
<portlist>
registration
{normal|fixed|forbidden}
in global configuration mode.
This is shown in Table 320.
T
A B L E
3 2 0
S
E T
G
V R P
P
O R T
R
E G I S T R A T I O N
C
O M M A N D
Format
Mode
Function
set gvrp port
<portlist>
registration
{normal|fixed|forbidden}
global config
This configure
type of GVRP
registration in
port
Result:
This configures type of GVRP registration in port.
Note:
By default, system port GVRP registration status is
normal, this command is to setup port GVRP registration
type. There are three types of registration types:
Result
Purpose
Steps
