ZXR10 2920/2928/2952
(V1.0)
Access Switch User Manual
（
Volume I
）
246
Confidential and Proprietary Information of ZTE CORPORATION
T
A B L E
3 9 9
S
E T
Z
T P
C
O M M A N D
Format
Mode
Function
set ztp
{enable|disable}
group config
This enable/disable
the system ZTP
function
Result:
This enable/disable the system ZTP function.
Note:
By default, system ZTP function is enabled. When
system ZTP function is disabled, contents of switch topology
information table are cleared, and ZTP packets processing is
suspended.
2. To enable/disable port ZTP function, use command
set
ztp port
<portlist>
{enable|disable}
in group config mode.
This is shown in Table 400.
T
A B L E
4 0 0
S
E T
Z
T P
P
O R T
C
O M M A N D
Format
Mode
Function
set ztp port
<portlist>
{enable|disable}
group config
This enable/disable
port ZTP function
Result:
This enable/disable port ZTP function.
3. To enable/disable trunk ZTP function, use command
set
ztp trunk
<trunklist>
{enable|disable}
in group config
mode. This is shown in Table 401.
T
A B L E
4 0 1
S
E T
Z
T P
T
R U N K
C
O M M A N D
Format
Mode
Function
set ztp trunk
<trunklist>
{enable|disable}
group config
This enable/disable
trunk ZTP function
Result:
This enable/disable trunk ZTP function.
Important!
By default, ZTP function of all ports/trunks is
enabled. If ZTP function of a port/trunk is disabled, ZTP
packets processing of port/trunk is suspended.
Note:
A port/trunk can collect and send ZTP information
normally only when both ZTP function of the port/trunk and
system ZTP function are enabled.
4. To configure ZTP parameters use the following commands
in group config mode as shown in Table 402.
