©2022, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
46
4.
Make sure that while preparing the file in Z-SUITE you chose an appropriate
printing profile, that is, the print settings match the type of used resin. If the profile
is correct, enable
Additional support exposure time
option.
5.
Check if the FEP film is not bent, deformed, or perforated. Replace the FEP film if
you notice such defects.
6.
Contact the Support Center at:
http://support.zortrax.com/support-form
.
