ZOLL Base Powercharger 4x4, Service Manual

Page: 64 / 75

DISASSEMBLY PROCEDURES
VII-13
5. REMOVING THE POWER ENTRY MODULE
TOOLS REQUIRED:
•
No. 1 Phillips head screwdriver
•
Adjustable Wrench
1. Remove the Base Pan as described on page VII-3.
2. Remove the Main PCB as described on page VII-5.
3. Remove the Heat Sink as described on page VII-7.
4. Remove the Transformer as described on VII-9.
5. Remove four (4) screws from the lower mounting bracket of the
Transformer.
6. Remove the Lower Bracket of the Transformer.
7. Remove two (2) screws securing the Rear Plate to the Upper Housing.
8. Remove the Rear Plate and Power Entry Module together as a unit.
9. Remove grounding screw from the Rear Plate.
10 Remove two (2) screws securing the Power Entry Module to the Rear Plate.
11. Remove the Power Entry Module by sliding through the Rear Plate.
INSTALLING THE POWER ENTRY MODULE
TOOLS REQUIRED:
•
No. 1 Phillips head screwdriver
•
Adjustable Wrench
1. Reverse steps 2 thru 11 above.
2. Install the Base Pan as described on page VII-3.
NOTE:
•
Screws (above) to be torqued 7-9 inch pounds. The two screws securing
the Power Entry Module to the rear plate should be torqued 4-5
inch pounds.