ZOLL Base Powercharger 4x4, Service Manual

Page: 61 / 75

DISASSEMBLY PROCEDURES
VII-10
4. REMOVING THE TRANSFORMER
TOOLS REQUIRED:
•
No. 1 Phillips head screwdriver
•
Needle Nose Pliers
1. Remove the Base Pan as described in VII-3.
2. Disconnect the PCB Supply Harness fastons and the Power Supply Harness
fastons from the top of the Transformer.
3. Loosen four (4) screws from the upper mounting bracket of the Transformer.
4. Remove the upper mounting bracket and screws.
5. Remove the Transformer.
INSTALLING THE TRANSFORMER
TOOLS REQUIRED:
•
No. 1 Phillips head screwdriver
1. Reverse steps 2 thru 5 above.
2. Install the Base Pan as described on Page VII-3.
NOTE:
•
Screws (above) to be torqued 7-9 inch pounds.
•
The PCB Power Harness is routed under the ground wire (attached to
the rear plate). If mis-routed, the Base PowerCharger
4x4
may exhibit HI-POT
failures or fuses blowing.