ZOJE ZJ5820, Operating Manual

Page: 103 / 108

10. Appendix 1
10-3. Alarm Information List
Malfunction
code
Name of Malfunction Method for Settlement
System Malfunction
E-001
IPM over-voltage or
over-current
Turn off machine and check the device as below:
1
、 Check the input voltage ；
2 、 Initialize the main motor again ；
3
、
Check the load at the main-shaft and the
blockage at the mechanism
；
4 、 Check the main motor ；
5
、
Check the mother board.
E-002
Supplementary device (24V)
over-voltage
Turn off machine and check the device as below ：
1
、
Check the short connection at control cable of
solenoid valve
；
2
、
Check the condition of expansion board
E-003
Supplementary device (24V)
low-voltage Turn off machine and check the device as below
：
1
、
Check the condition of expansion board
E-004 EEPROM Error
Turn off machine and check the device as below
：
1
、
Check the installation of head board
；
2 、 Check the connection of X9 cable.
E-005 Motor running error
Turn off machine and check the device as below ：
1
、
Check the load at the main-shaft and the
blockage at the mechanism
；
2 、 Check the main motor ；
3 、 Initialize the main motor again ；
4
、
Check the mother board
Special Malfunction
E-006 Press Pause key at ready status Release pause switch
E-007
Press Pause key at ready
sewing
Press RESET key
E-008 Pause Key bad connection
Turn off machine and check the device as below ：
1 、 Check the installation of pause switch ；
2
、
Check the connection of the pause cable.
E-009
Start Switch is held or bad
connection at start switch Release the start switch or turn off machine. And
check the connection of start switch
E-010
Presser Switch is held or bad
connection at presser switch Release the start switch or turn off machine. And
check the connection of presser switch
E-011 Machine head is tilted.
Turn off machine and check the device as below ：
1 、 Check the installation of safe switch ；
2
、
Check the connection of the safe switch cable.
E-012
Needle bar upper position
abnormal
Turn the wheel to the upper position
E-013 Synchronization signal Turn off machine and check the device as below
：
94