![background image](http://html1.mh-extra.com/html/zodiac/dual-link/dual-link_instructions-for-installation-and-use-manual_936316038.webp)
37
Configuring the setpoint:
Check that the setpoint has been set to its maximum on the heating system.
Configure the desired water temperature setpoint. The default value is 28°C.
This value can be set between 15 and 32
°C.
In this case, the temperature sensor of the chlorinator measures the water temperature.
• Press
. Browse the menu using the
buttons.
Press
to confirm.
•
Depending on the heating system (in particular when using a heat pump), there may be a delay of a few
minutes between the time the chlorinator closes the AUX2 contact to activate the heating system and the
effective start-up of the heating system (heat pump compressor).
•
The chlorinator displays the measured water temperature:
heating stopped
heating in operation
The water temperature is measured by the water temperature sensor of the chlorinator:
- If the measured water temperature
falls below
the setpoint value by 1°C or more
(e.g. 28°C -1°C
= 27°C), the relay is closed to activate the heating system.
- If the measured water temperature
is equal to or greater than the setpoint value by 1°C or more
(e.g. 28°C +1°C = 29°C), the relay is opened to deactivate the heating system.
EN