![background image](http://html1.mh-extra.com/html/zodiac/dual-link/dual-link_instructions-for-installation-and-use-manual_936316047.webp)
46
5.4 I Routine use
5.4.1 Adjusting chlorine production
The factory setting for "conventional" chlorination is 50%. It can be manually set to between 0 and 100% in intervals of
10% from the "main screen" by pressing
. The setpoint value remains valid until next modified.
"Conventional" chlorination refers to the manual management of chlorine production (outside of "Boost"
mode or "Low" mode, and with no connected "ORP" regulation).
5.4.2 "Boost" mode
In some cases, the pool may require a higher than normal chlorine level, for example during times of high use, bad
weather or at the start of the pool season.
"Boost"
mode is used to increase the chlorine level quickly.
"Boost"
mode operates for 24 consecutive hours at a 100% production rate.
If the programme is configured to perform chlorination for 12 hours a day,
"Boost"
mode is activated for 12 hours the
first day and for 12 hours the second day.
If the filter pump is connected to the appliance, it also operates in
"Boost"
mode. The chlorination and filtration timers
are temporarily ignored throughout the duration of Boost mode.
Once
"Boost"
mode has been deactivated, the appliance and the filter pump resume the programmed operations.
- If the appliance is equipped with a Dual Link module, Boost mode does not take into account the ORP
value.
"Boost"
mode has priority over ORP regulation.
- Boost mode can be activated even if the water is too cold (<15°C).
• Press
.
Time remaining
for "Boost"
mode
•
If the appliance is in Low/Cover mode, you must confirm that you want
"Boost"
mode to cancel the settings
implemented for
"Cover"
or
"Low"
mode.
5.4.3 "Low" mode
"Low"
mode is designed to reduce chlorine production when the pool is covered or during periods of low pool use.
Chlorine production must be reduced when the pool is not used very often and/or when the pool water is not exposed
to UV rays, etc.
Production in
"Low"
mode can be configured in the settings of the main menu from
"Low/Cover"
mode.
"Low/Cover"
mode can be configured from 0% to 30% in intervals of 10%. The programmes remain active when the
appliance is in
"Low/Cover"
mode.
• To manually access
"Low"
mode, press
.
•
To leave
"Low"
mode, press
again.