![background image](http://html1.mh-extra.com/html/zodiac/dual-link/dual-link_instructions-for-installation-and-use-manual_936316009.webp)
8
❷ Installing the chlorinator
2.1 I Installing the cell
•
The cell must be installed on the piping after the filtration system, after any measurement sensors, and
after any heating system.
Installing the chlorinator only
Installing the chlor optional
module
• The cell must always be the last element placed on the pool return pipe (see diagram).
• It is always recommended to install the cell on a by-pass. This assembly is MANDATORY if the
flow is in excess of 18 m³/hour to avoid head loss.
• If you installed the cell on a by-pass, it is recommended to fit a check valve downstream from
the cell instead of a manual valve, to avoid any risk of incorrect configuration which could
result in poor circulation inside the cell.
12.5 cm
21.5 cm
32 cm
11 cm
15.5
cm
21.5
cm
11 cm
21.5 cm
•
Make sure that the cell is placed HORIZONTALLY. The water should flow from the electric connections
towards the opposite side.
•
Use the screw-on fittings to fix the cell to the pipes.
•
For Ø63 mm pipes, glue them directly to the screw-on fittings. For Ø50 mm pipes, use glue-on PVC adapters
of the corresponding diameter (grey models; the white models are for 1 ½’’ UK pipes).
•
Connect the cell power cord following the wire colour codes (red, black and blue connectors) and then refit
the protective cap. The two red wires can be connected to one or the other red terminals on the electrode.