Section 8. Troubleshooting
8.1 Using the Information LED for Troubleshooting (3000 WD Cleaner)
The Information LED on the control unit flashes in a specific sequence to indicate one of three possible
cleaner malfunctions.
Information LED Flashing
Solution
LED flashes once with one second
interval.
Unplug the floating cable from the control unit and reconnect.
If the problem is not resolved through troubleshooting, contact Zodiac
Technical Support at (Canada) 1-888-647-4004.
LED flashes twice with one second
interval
Turn cleaner wheels to ensure they are not jammed.
Check brushes for debris.
Start a new cleaning cycle.
If the problem persists, contact Zodiac Technical Support at (Canada)
1-888-647-4004.
LED flashes three times with one
second interval
Check the pump axis for debris.
Check propellor for debris.
Clean the filter.
Start a new cleaning cycle.
If the problem persists, contact Zodiac Technical Support at (Canada)
1-888-647-4004.
8.2 Viewing Cleaner Status Information for Troubleshooting
(3010 WD and 3510 WD Cleaner)
Information about your cleaner's current status and any relevent error condition is available through a
troubleshooting status screen. To view this information:
1. Remove cleaner from the pool and turn power off.
2. Press
and
at the same time and hold for at least five (5) seconds.
The following cleaner operation messages are displayed consecutively for three (3) seconds:
Total hours cleaner has operated since new.
Last error code (if cleaner has had at least one error).
Time (in operating hours) the error occurred.
After cycling through each message, control unit returns to current day and time display.
Page
21
ENGLISH
Zodiac
®
3000 WD, 3010 WD, & 3510 WD Robotic Pool Cleaner
|
Owner's Manual
