Figure 23. Cleaner Correctly Stored on Caddy
Section 5. Programming the
Cleaner
(3010 WD and 3510 WD only)
You can program up to seven preset cleaning cycles to
run the cleaner on a specific day and time when you are
away from the pool.
NOTE:
You cannot change programming or display
current day and time during a cleaning cycle.
5.1 Displaying Current Day and Time
•
Press
to display current day and time in
24-hour clock format.
Current day and time is displayed for 5 seconds.
4.9 Storing the Cleaner
The cleaner must be cleaned regularly using slightly
soapy clean water. Do not use solvents such as
trichlorethylene or its equivalent. Rinse the cleaner
generously using clean water. Do not let your cleaner
dry in direct sunlight near the pool. The cleaner must be
stored on its caddy so that it dries quickly.
1.
Place the rear wheels on the caddy side wedges.
2.
Place cleaner in vertical position on the caddy
base and clip to hook (Figure 23).
3.
Disconnect the cable from the control unit.
Replace the protective cap on the control unit.
4.
Starting at the cleaner head. Remove all coils
and tangles from the cable (Figure 22).
Figure 22. Smooth the Power Cable
5.
Loosely coil the power cable starting at the
cleaner and moving toward the connection point
at control unit. Store the cable by wrapping
it around the hook located on the front of the
caddy (Figure 23).
Page
14
ENGLISH
Zodiac
®
3000 WD, 3010 WD, & 3510 WD Robotic Pool Cleaner
|
Owner's Manual
