ZMC408CE Motion Controller Hardware Manual V1.5
connect carefully.
When speed is met, use low-speed differential pulse preferentially. When high-speed
differential pulse interface is used, please make sure controller internal digital ground
is connected to driver high-speed pulse reference ground.
Please use STP, especially in bad environments, and make sure the shielding layer is
fully grounded.
Some servo drives are not isolated by optocoupler. At this time, the GND must be
connected to the GND of the driver. The encoders of most drives are not isolated by
optocoupler. When connecting the encoder, GND must be connected.
3.8.2.
Basic Usage Method
(1)
Please follow the above wiring instructions to wiring correctly.
(2)
After powered on, please use ETHERNET or RS232 (default parameter, it can be
connected directly) to connect to ZDevelop.
(3)
Set axis parameters, such as, ATYPE, UNITS, SPEED, ACCEL, FWD_IN, REV_IN, etc.
(4)
There are many parameters related to pulse axis, they can be set and checked
through relative instructions, please see “axis parameter and axis status” of “ZBasic”,
or see “ZDevelop/View/Axis
parameter”.
Summary of Contents for ZMC408CE
Page 1: ......