ZMC408CE Motion Controller Hardware Manual V1.5
The voltage to open
<15V
<14.5V
The voltage to close
>15.1V
>14.7V
Minimal current
-2.3mA (negative)
-1.8mA (negative)
Max current
-7.5mA (negative)
-6mA (negative)
Isolation mode
optoelectronic isolation
Note: the above parameters are standard values when the voltage of controller power
supply (E+24V port) is 24V.
→
Wiring Reference
→
Wiring Note:
⚫
The wiring principle of high-speed digital input IN (0-3) and low-speed digital input
IN (4-23) is shown in the figure above. The external signal source can be an
optocoupler, a key switch or a sensor, etc., all can be connected as long as the
requirements on output of electric level can be achieved.
⚫
For the public end, please connect the "EGND" port on the power supply to the "COM"
terminal of the external input device. If the signal area power supply of the external
device and the power supply of the controller are in the same power supply system,
this connection also can be omitted.
3.2.2.
Basic Usage Method
(1)
Please follow the above wiring instructions to wiring correctly.
(2)
After powered on, please select ETHERNET or RS232 to connect to ZDevelop.
Summary of Contents for ZMC408CE
Page 1: ......
