ZMM Haskovo PELLETHERM V.4 LT SERIES, Manual

Page: 29 / 48

Pelletherm V.4 LT 29
The tilt angle (between the auger axis and the horizontal plane) influences the
auger’s productivity, i.e. the fuel feed rate adjusted for specific operation
mode. If the tilt angle has been changed, then the burner adjustments have to
be changed also, in order to ensure a specified heating output.
5.4.12. FILLING THE TRANSPORT AUGER WITH FUEL.
The transport auger of the pellet burner from series “GP xx sc” has to be connected to
constant power supply, the fuel hopper has to be filled with pellets and after that should wait
until the pellets start to drop from the auger’s outlet. Then disconnect the auger’s power
supply cable and connect it to the right side of the burner’s main module. After completing
the above conditions switch the system ON.
The manufacture company reserves its right to change the system construction, without
engagement to inform the end users.
5.4.13. CONNECTING THE SYSTEM TO THE POWER SUPPLY.
Connecting the system, consisting of a hot water pellet boiler from series “Pelletherm V.4 LT”
and a pellet burner from series “GP xx sc”, can be performed through the power supply
cable, standard provided in the product delivery kit.
The manufacturing company reserves its right to change the above mentioned
modules construction, without engagement to inform the end users in
advance.
During initial start of the pellet burner and also after complete fuel exhaustion
within the auger’s pipe, it must be refilled with pellets again – this process is
presented in the burner’s manual book. The procedure must be shown and
explained to the end user as well.
5.4.14. EXEMPLAR HYDRAULIC SCHEME.
The recommended exemplar hydraulic scheme for connecting a hot water pellet boiler from
series “Pelletherm V.4 LT” to a heating installation with OPENED type expansion tank is
presented on the next figure.