Pelletherm V.2 M01 49
6.9. SAFETY AND ADDITIONAL RISKS.
6.9.1. RISKS RELATED WITH USAGE OF A PELLET BOILER.
The automated hot-water pellet boiler "Pelletherm V.2 M01" is designed and manufactured in
compliance with the main safety requirements of the European standards and directives in
force. Hazardous conditions can occur in the following cases:
The hot-water pellet boiler "Pelletherm V.2 M01" is used incorrectly;
The equipment is installed by unqualified personnel;
The safety instructions described in this manual are not complied with.
6.9.2. ADDITIONAL RISKS.
The equipment is designed, constructed and produced in accordance with current safety
standards. Although possible risks arising from improper use are considered, there may
occur the following risks:
Risks of burns caused by high temperatures as a result of the combustion process in
the combustion chamber and/or access to the door of the combustion chamber,
during cleaning the burner or not burnt out material in the ash container;
Electrical shock risks at indirect contact. The boiler is connected to the electric net
and controlling modules are separated in an electric panel equipped with the
necessary devices for protection against overload and short circuit. It is mandatory to
ground the boiler by an authorized technician;
Risk of injury to fingers during operation when opening/closing, cleaning. It is
recommended to use appropriate personal protective equipment;
Risk of suffocation in case of insufficient chimney draught, blockage of the tubes
bundle of the boiler or improper sealing of the flue.
6.10. COMPLETION OF EQUIPMENT WARRANTY CARD.
Attached WARRANTY CARD is completed by writing the necessary
information into the indicated fields, as in places for signature and seal is
necessary to put the corresponding signatures and seals, to ensure the
VALIDITY of the WARRANTY CARD of the hot-water pellet boiler series
"Pelletherm V.2 M01".
6.11. ACTIONS AFTER COMPLETION OF THE SERVICE LIFE OF THE EQUIPMENT.
After completing the service life
of the boiler, its destruction I smade in environmentally
friendly way. For this purpose, it is disassembled, and the modules are handed over to the
secondary raw materials purchasing places, observing the separate collection principles.
