Pelletherm V.2 M01 36
Prompting question does not appear if the boiler has already been activated
or is starting and stopping with the key "START", which is recommended.
To initiate the operation of the boiler it is pressed the "S" button, as shown in the figure. After
starting the boiler operation, on the display will be displayed message shown in the following
figure.
Figure 6.6. The display of the boiler containing information about the mode of operation of
the boiler - in this case it is made check of the fan for air supply.
TEST – BLOWING: –
shows the operating mode - in process is start blowing
of the boiler grate by the fan (show current phase of the ignition of the burner).
„ 32
о
”
-
shows (on the display below on the left, above the button "S") the
temperature the water in the hot-water boiler (in degrees Celsius). The
temperature is shown in the presence of a sensor for water temperature in the
boiler and respectively activation of this option.
„FC: 0%” -
shows the intensity of the lightness of the photosensor in
percentage - it is shown on the bottom right of the display, above the button
"ESC".
Figure 6.7. The display of the boiler show information about the mode of operation of the
boiler - in the case mode of ignition of the initial dose from the fuel.
S
_
+
ESC
TEST - BLOWING
32
o
FC: 0%
S
_
+
ESC
IGNITION 1 150
32
o
FC: 0%
