ADJUSTMENTS
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
47
ZI-BAS205 / ZI-BAS250
47
Adjusting the work table at right angles to the saw blade
Raise upper blade guide (BG) fully.
Loosen the two locking screws (LS) on bench
angle gauge.
Using a try square (TS), set the table at right
angle to the blade and tighten the locking screws
(LS) again.
Loosen locking nut (LN) and adjust the limit stop
screw (SS) until it touches the work table (WT).
Tighten locking nut (LN) again.
Adjusting the saw table lateral alignment
Procedure:
To disassemble the worktable from the bench
angle gauge, loosen the three screws (M6x16),
washers and nuts.
Align the work table in a position where the saw
band runs through the middle of the table insert (T).
Tighten the three screws (M6x16) again.
Adjusting the rip fence
The rip fence is clamped to the front and can be used on both sides of the blade.
