ADJUSTMENTS
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
46
ZI-BAS205 / ZI-BAS250
46
Mount the bench angle gauge (AG) with the two
locking screws (LS).
Close the lower front door (F).
Fix the worktable with three screws M6x16,
three washers and three nuts (M6) to the bench
angle gauge (AG).
Fix the u-shaped clamp (K) with two screws
(M6x20) and two nuts (M).
Height-adjustment of the blade guard
ZI-BAS205
The blade guard protects against unintentional
contact with the saw blade and against flying chips.
ZI-BAS205: loosen the locking screw (LS) by
turning it counter clockwise.
To adjust the height between blade guard and
workpiece, turn the hand wheel (H) until the
desired height is reached.
ATTENTION:
Always lower the upper saw band
guide as close as possible (max. 3 mm) to the
workpiece.
ZI-BAS205: retighten the locking screw (LS) by
turning it clockwise.
Adjusting the tilt of the worktable
The following steps are necessary to adjust the cutting angle:
After loosening both locking screws
(LS), the work table tilts steplessly
through 45° to the blade.
By means of the angle scale (AS)
the inclination angle can be read off
the indicator (I).
Retighten the locking screws (LS)
after adjusting the inclination of the
worktable.
