I L L U S I O N
21
Trim nose to a blunt point.
Nose sanded to shape.
Nose blocks in place.
Trim the nose back, so that it is not so sharp.
If it were left sharp, it could hurt…
Sand the nose to a nice round shape.
At this time, you should look over the entire hull,
and sand any glue bumps or uneven seams, etc.
Center Section Nose Blocks
These are the two shaped balsa blocks.
They fair the front of the center section for less wind
resistance.
Lightly sand the fuzz off the edges, but do not
round the edges.
Test fit, and then glue them tightly to each side, at
the front of the center section.
