I L L U S I O N
20
Decks clamped in place at the nose.
Deck clamped at the rear.
Round these edges, but not others.
slightly pull the sides out to the deck.
Continue adding weight until the entire deck is in
contact all the way around. Check the transom from
behind. Check the nose as well.
Allow to cure overnight.
After the deck sheeting is fully cured, use your
plane and 80 grit to sand flush.
Give the whole boat a good sanding with your 80
grit block.
Use wood filler to fill any gaps or gouges, and to
build up the nose, if necessary.
After the filler is dry, sand it with 80 grit, using light
pressure.
At this point, you can round the deck where it meets
the sides. You can also round the bottom to side
seam.
Do not round any other edges. We need them
sharp.
