I L L U S I O N
9
Fuselage sides being installed in framework.
Rear radio box mounts.
Note blind nuts glued to bottom of mount.
When done, check to make sure everything is flat,
flush and square, and then reglue all joints with thin
CA.
Fuselage sides
Remove and sand the two fuselage sides, and
carefully slip them up into the bulkheads from the
bottom.
You will have to lay them into position, and “rock”
them into place.
The fuselage sides start at the transom and go to
bulkhead 7. Do not glue in place yet.
Locate the two radio box mounts with holes in them.
Glue the two mounts together, aligning the holes.
Glue the two 6-32 blind nuts into the assembled
mount. The blind nuts go in the part of the mount
without tabs. Use the 6-32 screws and washers to
draw them into place. Use medium CA to fix them in
place.
