Page 28 of 32
801910 v3.05 09.20 HT BCS Commercial Instructions
Commissioning
Pull both levers
forward
Safety
sensor
7.5
-
Safety Sensor Calibration (Boiling models)
1. With the unit in Normal operating mode and with
the safety enabled
2. Turn the power OFF
3. Pull both tap levers to the forward position
4. Turn ON the power
5. The unit will calibrate the safety switch
6. Return the levers to the neutral position.
7. To check the calibration, dispense Boiling water,
in normal light conditions with the safety enabled.
Light intensity varies from site to site, therefore it is recommended that a re-calibration be performed at the
time of the installation. All direct natural sun light must be shaded from the HydroTap, during the calibration.
This can be achieved by closing any nearby curtains, blinds, or by shielding the HydroTap with a dark cloth.
