A4 Errorlist
If troubles occur the controller cuts the current travel program. The display starts flashing and a short
message will be displayed with number including a hint to possible causes.
->Press any key to delete the error message.
All messages are stored in the error list
/STATISTICS/STAT0
.
Individual monitoring functions can be blocked in menu /ZA_INTERN by means of the parameters MASK
1 to 3. To do this, the corresponding error number has to be put in.
No. Error Reason
Prüfe L1, L2, L3
Outage of a mains phase.
0
Memory empty
No error: Is put in in the error list if no error has occurred up to now.
2
A_NEG<A_MAX
Range limit /DECELERATING/A_NEG has to be smaller than
/INSTALLATION/A_MAX.
3
Phase failure
Outage of a mains phase at start-up trial or at stop.
4
Phase failure
Outage of a mains phase during running.
Reference to 3 & 4:
If parameter /INTERFACES/QUIT is set to AUTOMAT., the drive
automatically starts running again after all mains phases have been fed.
5
Temp.Motor
Monitoring of the motor temperature (Terminal P1 P2) has responded at
standstill.
6
Temp.Motor
Monitoring of the motor temperature has responded during running.
Reference to 5 & 6
If parameter /INTERFACES/QUIT is set to AUTOMAT. the drive automatically
starts running again after cooling of the motor.
7
V1< V2< V3
V1 has to be smaller than V2 and V2 has to be smaller than V3.
8
Wrong direction
The car has moved a distance in the wrong direction.
9
No starting
The controller does not receive any signal from the encoder within the
monitoring time /ZA-INTERN/T_GUE.
10
No stopping
Although the control device has closed the mechanical brake via contact
"MB", the drive does not come to a halt.
11
RV1 or RV2
Both directions set have been triggered.
12
RV1 /RV2 missing
A speed has been triggered without any direction set.
14 Encod.
drop out
The signal of the encoder has broken down at start-up or during running.
15
R_NEG too small
The lower limit of the range is achieved. Increase the corresponding
16
A_NEG too small
parameter.
17
R_POS too small
18
A_POS too small
19
V1 too small
