Operation and settings 27
4.3
Summary of parameters
The parameters are divided into menus (see figure 4.4).
Only the four stressed menus are important
for commissioning
.
Prior to the first run, it is necessary to put in the installation data in the menu
"INSTALLATION"
. If the
parameter AUTO is selected in this menu, the parameters are preset according to the installation data.
Experience has shown that only small changes are necessary for optimization.
Indication: State of the inputs and outputs,
actual and nominal speed
Indication: Distances and times
Indication: Statistic indications and
administration of error lists
Input:
Travel speeds
Input:
Acceleration ramp and
start-up reaction
Input:
Deceleration ramp and
brake reaction
If necessary: Intervention of the speed regulator
If necessary:
Possibility to allocate a password or to
change to the national language.
Single input prior to the first travel
If necessary:Change of the factory set function
of inputs and outputs
This menu only appears in case of control devices
disposing of an expansion card
Reserved for special applications
Figure 4.4 Menu outline
MONITOR
****************
****************
STATISTIC
****************
ACCELERATING
****************
DECELERATING
****************
INSTALLATION
****************
INTERFACES
****************
EXPANSION
****************
ZA-INTERN
****************
TRAVELLING
****************
CONTROLLER
****************
OPERATING
****************
DIST. & TIMES
