Zetor Proxima HS 100, Operator'S Manual

Page: 80 / 212

Before a drive with the new tractor get to know how to shift gears and try individual positions
of the shifting lever when the engine is stopped.
During normal operation and before you set up, make sure that the technical condition ensures safe
operation of the tractor.
Before you start the engine
Non-permitted starting
*Coolant heater
Before you start the engine, make sure:
1.
that the tractor is properly braked
2.
that the main gear shifting lever is in the neutral
position
3.
that the reversing lever is in the neutral position
4.
that the PTO switches are off.
If the clutch pedal is not pressed - the engine cannot be
started - the starting interlock switch is not actuated.
Note:
Before the entire starting we recommend you to
prime the fuel system with some strokes of the manual
feed pump.
PW15N029
It is forbidden to start the tractor by short-
circuiting the starter clamps. Start only from the
driver´s seat. It is necessary to disconnect minus pole
of accumulator and all the shifting levers including
PTO shaft shifting lever to be shifted in neutral
position with any manipulation or repair of the starter.
The starter´s clams are covered with a cap.
C15N125
Is mounted on the right side of engine block.
output 1,000 W
voltage 220 V
C209
OPERATION
79