Zetor MAJOR HS, Operator'S Manual

Page: 83 / 140

Selection of holes in bracket
*Lower draw bar with slipping out end pieces
Always check the position of slipped-out end pieces and locking pegs, see fig. (3).
*Front three-point hitch
During transport of the carried tools, the hinge must always be hydraulically secured in the
lifted position by valves located on the left side of the tractor above the front axle. This hydraulic
securing is recommended even in the case when no machine is connected to the three-point hinge.
The connection of upper draw bar to some of the holes
(a), (b) or (c) of bracket influences:
the sensitivity of hydraulic control. With connected draw
bar in a hole (a) the sensitivity of regulation is the greatest,
in (c) hole the smallest.
NM13N057
Lower draw bar of linkages are equipped with semi-
automatic protruding CBM end pieces. They enable
connecting of tools behind a tractor. After protruding
securing pegs (1) slip the end pieces out (2). Slipped-out
end pieces are attached to tightening pins of mounted
tools.
After connecting the mounted tools, release the arms of
hydraulics. By lowering them down and reverse travel of
a tractor, endpoints (2) are slid onto draw bars and
automatically are locked in working position by means of
locking pegs (1).
E459
It is designed for connecting the frontally carried
agricultural machines according to ISO 8759-2.
E461
HITCHES
82