Zetor CRYSTAL HD 150, Operator'S Manual

Page: 210 / 234

Filling, controlling and draining hole of oil of front drive axle
Front PTO
1 - Transmission oil drain hole
2 - Transmission oil pouring and inspection opening (after
unscrewing the check screw the oil level must reach the
lower edge of the inspection hole)
c18n009
Inspection, filling and draining oil is done by a one hole
after turning reducer according to figure.
1. amount of oil inspection - hole in the horizontal axis of
a reducer (after unscrewing control screw the level of oil
must reach the brim of checking hole)
2. filling oil - hole at the top
3. draining hole - hole at the bottom
C18N142
The inspection and filling plug of oil (1) is situated on the
front side of the front PTO case.
Note: The front PTO with the standard turning direction is
equipped with a hollow bolt of the oil cooler hose instead
of the inspection and filling plug. Perform the check after
removing the hollow bolt.
After unscrewing of the inspection plug the oil
level must reach the bottom edge of the inspection
opening. During the oil replacement the oil cleaning
strainer (2) must be cleaned. The cleaning strainer is
accessible after the disassembly of the locking ring
and removal of the cap.
C18N145
MAINTENANCE INSTRUCTIONS
209