Zetor CRYSTAL HD 150, Operator'S Manual

Page: 206 / 234

Check and replacement of oil in gear box
Draining and checking holes
1. drain plug of oil from clutch box
2. drain plug of oil from gearbox
3. drain plug of oil from final drive housing
4. drain plug of oil from final drive housing box
5. drain plug of oil from final house driving box
6. Pouring opening for gear oil is placed in hydraulic mechanism housing. Accessible from the rear part of
the tractor
C18N143
Checking the oil in gearbox
After draining oil
The height of oil in gear box set is checked by oil level
indicator which is placed at the right rear part of the
gearbox behind the right hydraulic roller.
A - Standard oil filling
Carry out the check always with the engine
stopped.
FH12N016
1 - Clean the magnet (part of the lid) and the suction filter
screen insert (1)
2 - Replace the hydraulic oil pump and transmission
distributor filter inserts
3 - After cleaning, screw back in all the drain screws
4 - Fill in the oil, start the engine, let it run approx.
2 minutes
5 - After stopping the engine and calming the oil level in
the gear unit, check the oil level and top up the top edge
of the dipstick, if necessary, increase the filling to the
lower or upper dipstick gauge mark
C18N006
MAINTENANCE INSTRUCTIONS
205