Zetor CRYSTAL HD 150, Operator'S Manual

Page: 129 / 234

Console with a ø 80 ball module
Hitch for a single-axle CBM semi-trailer
Uncoupling of a single-axle trailer
Coupling of a single-axle trailer
When the drawbar eye of the trailer is installed on the hitch hook, it is hydraulically lifted together with the
trailer eye to the position where the bearing hooks snap under the pins of the hitch carrier.
The hydraulic lifting arms must then be lowered so that the carrier pins can make contact with the bearing
hooks - the telescopic pull rods must not be stretched.
The console with a ø 80 ball is only used to
connect semi-trailers with a hitching device designed
for a ø 80 ball.
Releasing the hitch, fig. (A):
By moving the lever (1) in the arrow direction you will
remove the locking wedge (2).
Locking the hitch, fig. (B):
By moving the lever (1) in the arrow direction you will
retract the locking wedge (2).
C18N104
The hitch for a single-axle semi-trailer may be equipped
with a hook (A) or with a swinging draw-bar (B).
Replacing the hook with the swinging draw-bar (C):
1 - Lower the hitch.
2 - Release and remove the pin (1).
3 - Remove the hook in the arrow direction.
Install the swinging draw-bar in the reverse order.
C18N105
Lift up the arms of the rear three-point hinge to the upper
position when the maximum position regulation is set.
Move the lever of the hinge control for one-axle trailer
from the position (a) to the position (b) (the lever is located
on right side of the drivers seat).
Lower the arms of the rear three-point hinge. This way the
hinge for the one-axle trailer is lowered as well and the
drawbar eye of the trailer can be disconnected from the
hitch hook.
When released, the lever of the hinge control for one-axle
trailer is returned from the position (a) to the position (b)
automatically.
FHD18N040
TRANSPORTATION
128