Zero UAV (Beijing) Intelligent Technology Co., Ltd. 29
Single Remote control operation
a)
Switch CH7 on your aircraft remote control from Maximum to minimum. Now switch 3 times in rapid succession to
enter single remote control operation. The gimbal will now be controlled by the aircraft remote controller.
Repeat
this operation by switching 3 times again to exit single remote control operation and enter double remote control
operation.
b)
To check whether you have successfully entered single remote control operation or not: slightly raise the throttle
stick, if all is in order, the gimbal will start stabilizing. It will tilt and roll to stay level and the CH7 switch will control
gimbal tilt.
c)
When the throttle is reduced to zero the gimbal will cease stabilisation.
Dual remote control operation
Push the throttle stick on the Gimbal remote control to its maximum. The gimbal will be at maximum stability. Use the
gimbal remote control to regulate the roll, tilt and pan of the gimbal.
NOTE:： If the gimbal fails to maintain roll and tilt stability after initialization it is necessary to increase the throttle control until
the camera maintains a level horizontal position and directional stability..
