Zero UAV (Beijing) Intelligent Technology Co., Ltd. 13
NOTE: Signal wire of retractable landing gear could be connected with empty channel of gimbal receiver, or it also could be
connected with empty channel of copter receiver.
3.1.9
NOTICE
1.
The Gemini flight controller and Gimbal controller both use the 5.7v power supply
. If the main voltage supply from the 6s
battery is used the equipment will be fried immediately.
2.
Please be sure to use a 6S LIPO battery to supply power to the gimbal. If a 4S or 5S battery is used, the gimbal will have
insufficient strength, will shake and behave abnormally.
3.
The XT90 power supply connector may easily become dirty and have a poor contact making the wires become too hot
after a flight. This may be rectified by:
–
Regularly clean with ethyl alcohol to eliminate carbon traces after sparking.
–
Replace the anti-ignition connectors using the genuine AMASS variety.
4.
There is COM port for each of the main controller and slave controller of HighOne-Pro,
the extension cord of main
controller is M-COM, and the slave controller is S-COM
. When upgrading the flight control firmware, insert the USB line
into its corresponding COM interface to start the upgrade operation (when upgrading the main controller, the OSD data
wire should be disconnected).
