Zero UAV (Beijing) Intelligent Technology Co., Ltd. 41
3.
After unlocking using CSC, slightly push the throttle. Check that motor mixing
is normal. According to your transmitter mode (Mode 1, Mode 2, Mode 3, etc.)
when executing the CSC the sticks can be moved in a “\/” shape or a “/\” shape.
Take the “/\”shape as an example; the throttle stick should be reduced to the
minimum and pushed to the left, the elevator stick should be reduced to the
minimum and pushed to the right. This example would apply to a Mode 2
transmitter (American standard)
4.
The Gemini ground station can monitor the state of two sets of independent
sensors at the same time, when the user observes that at least seven satellites
are in view of the GPS it is possible to arm the motors and take off.
NOTE: If remote controller can’t be unlocked, please do the following checking:
remote controller should be closed when checking the newest firmware
(F/S setting correctly, CH5 and CH6 are on position 3, throttle is in the
middle position). Combination stick command after checking and then
motor will start, otherwise it refused. It needn’t to be checked again except
energizing. But it should be checked again when power is disconnected. It
also should be checked again to the remote controller settings
Figure 29 GCS- satellites
