Zero HighOne-Pro, User Manual

Page: 31 / 97

Zero UAV (Beijing) Intelligent Technology Co., Ltd. 21

Single remote controller setting by following step:
1. Set both CH5 and CH6 to 3-position switches. CH5 and CH6 select the working mode of the flight control.
2. Fail Safe (F/S) should be set up with the controls in the following positions: Set both CH5 and CH6 of the remote control
to position 3. The throttle stick should be set to a position near the center (50%).
3. Set CH7 to use a lever to control the gimbal Pitch. On a Futaba this would be the RS or LS switch lever( in the side of
remote controller ). Switching CH7 of copter remote controller from up to down and back to up and repeats 3 times, then
copter will be controlled by single remote controller. Gimbal will follow the real time copter direction, gimbal roll is
horizontal, gimbal pitch is controlled by CH7.To switch to double remote control back from single remote control:
repeating switching CH7 up and down 3 times.
4. Set CH8 to a 2-position switch to control the camera shutter. Taking a picture at each switch, or starting/stopping
recording.
5. Set a 2-position switch or knob switch on the remote controller to control the retractable landing gear.
3.4.2 Setting up a dual remote control
3.4.2.1 Copter remote controller settings

Double remote controller-copter remote controller channel definition