ZHDN 2500-150
30
Temporary operation of lift
www.zepro.com
Ctrl 4
Spiral
Ctrl 3
Radio
Ctrl 2
Ctrl 1
C
on
tro
lP
ow
er
Sensor Power
G
ro
un
d
IN OUT
Ai 2
Ai 1
Di 1
Di 2
Di 3
Di 4
Di 5
Di 6
PA-
PA+
CSPWR
CS
+
B
E
C
2H1
B
E
C
2H2
B
E
C
Lock
B
E
C
Lock
U
7
U
6
U
5
U
4
U
3
U
5
U
4
U
2
U
1
U
0
Ctrl 6
O
ut
In
S
pk
-
S
pk
+
I-
I+
C
R
C
T
Ctrl 5
Outputs
S
en
so
rs
15A
Up
Down
Tilt
Two-hand operation
Control voltage
Sled out
Sled in
+12-24V
GND
Jumper
7
Temporary operation of lift
When the lift is installed, it is sometimes necessary to operate the lift functions in order to
change the position of the cylinders and the lift arms. To do this, the lift control card can be con-
nected temporarily to run the functions.
7.1
Connection
1. Connect a suitable control device to the control card, see illustration below. The number of
available functions varies depending on the lift model.
2. Connect an earth connection (GND) to the control card, see illustration below.
3. C12-24 V to the control card protected with a 15 A fuse, see illustration below.
4. Insert a jumper between CSPWR and CS to simulate a cabin switch CS in the ON position,
see illustration below.
7.2
Operation
Use the control device to run the lift functions.
Take great care when running the lift functions and make sure nothing is trapped. There is a
risk of injury and damage.
m
WARNING!
7.3
Disconnection
1. Remove the jumper between CSPWR and CS.
2. Disc12-24 V from the control card.
3. Remove the earth connection from the control card.
4. Disconnect the control device from the control card.
Image 46. Temporary connection of lift control card
